Table of Contents
Advertisement
8-2-25,
AE OFFSET adjustment (VC-95 board)
is
All back (Cover lens with a black
Subject
cap.)
Measurement point
| CN655
Measuring instrument
'AF microcomputer data reading jig
'Adjustment page
F
Adjustment address
1E (AE OFFSET)
Specified value
Minimum value of 01 to 06
Adjusting Method:
1) Select adjustment page F and address EB with the
2)
3)
4)
5)
6)
adjustment remote controller, and set the adjustment data to
13.
(IRIS CONT level indication mode setting.)
Select the adjustment address 1E.
Change the adjustment data until the indication on the AF
microcomputer data reading jig is the minimum value in the
range of 01 to 06.
Read the data (D1) indicated on the AF microcomputer data
reading jig.
Change the adjustment address to store the adjustment data
in the memory.
Perform
"Standard
AE
level
and
Program
AE
level
adjustment."
8-2-26.
Standard AE level and Program AE level
adjustment (VC-95 board)
Color bar chart standard picture frame
| CN6SS
Subject
Measurement point
Measuring instrument | AF microcomputer data reading jig
Adjustment page
F
60 (IRIS REF NOR)
Adjustment address
61 (IRIS REF PO)
62 (IRIS REF SP)
Specified value
Deo-D1 2 59
Note: Perform
"AE
OFFSET
adjustment"
before
this
adjustment to obtain D1.
Adjusting method:
1)
Select the page 5 and the address 00 with the adjustment
remote controller, and set the data to 01.
2)
Select the adjustment page F and the adjustment address 60.
3)
Read the indication on the AF microcomputer data reading
jig and enter this data (Deo) into the adjustment address 60.
(Do0-Di 2 59)
4)
Convert Deo to decimal to obtain Deo'.
5) Obtain Dei' and De2' by the following formula.
De62*=D60~12
6)
Convert D61° and De2' to hexadecimal
and call respect
values Dé1 and De2.
7)
Select the adjustment address 61 and 62, and enter the
adjustment data De1 and Dez into respective addresses.
8)
Change the adjustment address to store the adjustment data
in the memory.
— 266 —
Advertisement
Table of Contents
