Table of Contents
Advertisement
7-1-5.
How to use practically
How to use:
How to set the adjustment mode and the TEST mode
Set RM-95 to the service mode. (HOLD SW "ON")
How to change and write data
Press the PAUSE button of RM-95. Pressing PAUSE button is not required for some RAM and I/O area.
Change and write
data of EE-PROM
Removing PROTECT is required. The PROTECT is removed by setting as follows:
PAGE 1
'Address 00
But CAMERA system don't need release, because don't set
PROTECT.
How to release each mode
Releasing from
Be sure to return the data of PAGE 1 address 00 to 00 from Ol, and then tum off the service mode
EE-PROM area
of RM-95.
Releasing from RAM
and 1/O area
Tum off the service mode or tum off the power, because hoding of data is not required.
In order to perform the pass track shift ----+~ 7
s+teseree Refer to page 283.
In order to inhibit the emergency detection:
serseeseeeree Refer to the list in page 288.
In order to check the emergency code +++
- Refer to page 289.
+ Refer to page 293.
+ Refer to page 291.
- Refer to page 290.
+ Refer to page 293.
- Refer to page 293.
In order to operate the motor singly
In order to check the function switch +--+
In order to check the mechanical switch
In order to read the A/D converted value +++»
In order to check the reception contents of the wireless remote control:
woe
oercee
— 236 —
Advertisement
Table of Contents
