Configuring Lan Hardware Parameters - Paradyne COMSPHERE 6700 Series Network Configuration Manual

Custom Network Interface Settings

Configuring LAN Hardware Parameters

5-2
Table 5-1 describes the fields on the Custom window.
Table 5-1. Custom Window Fields
Field Description
Interface The name of the interface.
Physical Address The physical address of the workstation.
IP Address Internet Protocol address (home address) for the workstation.
Subnet Mask Subnet mask bits. Used to partition IP addresses into network and
host portions.
Host Name Not required.
Domain Name Not required.
Name Name of the interface.
Type Ethernet, Token Ring, FDDI, SLIP, or PPP
IP Internet Protocol address (home address) for the workstation.
Domain Not required.
Use Hardware... to select and configure the following hardware-related
parameters for Ethernet, Token Ring, or FDDI networks:
Vendor
Board Type
Procedure
1. Choose Settings... from the Network menu. The
shown on page 5-1.
2. Choose Setup from the Custom window menu bar.
February 1998
Custom window appears, as
6700-A2-GB22-20