Automatically Connecting Interfaces - Paradyne COMSPHERE 6700 Series Network Configuration Manual

Configuration Files and Interfaces

Automatically Connecting Interfaces

3-4
Use Interface on the Network Configuration main menu to set up serial interfaces
to automatically connect at system startup. Also use this command to remove
interfaces from the automatic connection list.
NOTE:
You must configure the devices and the COMSPHERE 6700 Series NMS
interfaces before you can use this procedure to automatically connect those
interfaces. Also, the COMSPHERE 6700 NMS must be running.
To set up automatically connecting interfaces, choose Interface from the Network
pull-down menu. The Auto Connect Interfaces dialog box appears.
This dialog box shows all available interfaces not set up for automatic connection
in the left list box, and all interfaces previously set up for automatic connection in
the right list box.
To add an interface to the auto connect list, highlight the desired interface in
the Available Interfaces list box, then select Add.
To remove an interface from the auto connect list, highlight the desired
interface in the Connected Interfaces list box, then select Remove.
February 1998 6700-A2-GB22-20