Paradyne Comsphere 3830 User Manual page 45

COMSPHERE 3800 Series Modems – Model 3830
I n Identification
Provides useful information when upgrading or servicing the product.
I0 Displays product code (default is 144).
I1 Displays 3-digit firmware revision number.
I2 Performs an EPROM check.
I3 Displays serial number.
I4 Displays model number.
I5 Displays hardware part number.
I6 Displays software part number.
I9 Displays 3-digit firmware revision number (same as I1).
I10 Allows you to change the value displayed by I0:
I10=0 causes I0 to display 144 (default).
I10=1 causes I0 to display 240.
I10=2 causes I0 to display 480.
I10=3 causes I0 to display 960.
I10=4 causes I0 to display 120.
I11 Displays the program memory checksum.
I19 Displays the entire firmware revision number.
L n Speaker Volume
L0 Selects low volume.
L1 Selects low volume.
L2 Selects medium volume.
L3 Selects high volume.
M n Speaker On/Off
M0 Speaker always Off.
M1 Speaker on until carrier signal is detected.
M2 Speaker always ON.
O Return to Online or Data Mode
Returns modem to Data mode from Online Command mode.
P Pulse Dial
Sets the modem for Pulse Dial mode. See D command.
4-10
Table 4-2
(4 of 22)
Model 3830 AT Commands
November 1996 3830-A2-GB91-20