Paradyne Comsphere 3830 User Manual page 47

COMSPHERE 3800 Series Modems – Model 3830
X n Extended Result Code, Dial Tone Detect, and Busy Tone Detect
The X n command sets three configuration options simultaneously:
EXTENDED RESULT CODE
Informational messages such as VF (line) connect rate and Error Control
are displayed with the result codes.
Disable. Displays basic result codes: OK, CONNECT, RING, NO
CARRIER, and ERROR.
Enable. Displays basic result codes in addition to the CONNECT rate
message (for example, CONNECT 14400).
Add/EC. If error control is negotiated, attaches the /EC suffix to the
CONNECT rate message.
Add/V42,MNP. Attaches the V42b, V42, MNP5, MNP4, MNP3, MNP2, or
NoEC suffixes to the CONNECT rate message.
Use DTE Rate. Displays DTE data rate instead of line CONNECT rate
message.
DIAL TONE DETECT
Sets the modem for dial tone detection (enable) or blind dialing (disable).
Disable. Sets the modem for blind dialing.
Enable. Sets the modem for dial tone detect.
4-12
Table 4-2
(6 of 22)
Model 3830 AT Commands
Ext
Result Code
X0 Disable
X1 Enable
X2 Enable
X3 Enable
X4 Enable
X5 Add/EC
X6 Add/V42,MNP
X7 Use DTE Rate
November 1996
Dial T one Busy Tone
Detect Detect
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Enable Enable
Enable Enable
Enable Enable
Enable Enable
3830-A2-GB91-20