Ryobi RBC254SESO Original Instructions Manual page 18

OPERATION
4. Hold down the trigger lock and squeeze the
throttle trigger, and keep the throttle trigger
squeezed completely through steps 6.
Use your right hand to put the starter bit shaft
to the shaft hole on the engine. Make sure
that the starter bit is properly engaged.
Press and hold the electrical starter switch
button until the engine attempts to start. Do
not press the electrical starter for more than
4 seconds.
5. Set the choke lever to
and hold the electrical starter switch button
until the engine starts.
NOTE: If the engine does not start, repeat
the procedure from the step where you set
the choke lever to position.
Do not repeat the procedure more than
once. If the engine does not start after the
second attempt, see the solution instruction
for a flooded engine in the "Troubleshooting"
section of this manual.
6. Allow the engine to run for 10 seconds, and
then set the lever to position.
7. Hold down the trigger lock and squeeze the
throttle trigger to operate the product.
16
4
position. Press
5
6
1
7
1
2
1
2
3
1
2
4
4s 4s
3
4
4s 4s
2