Ryobi RBC254SESO Original Instructions Manual page 17

OPERATION
STARTING A COLD ENGINE BY
ELECTRICAL STARTER
1. Install the starter bit into the electrical starter
with the pentagon bit facing outside. Slide
the F/R button to the left until the pentagon
symbol shows on the F/R button.
2. Insert the battery pack into the electrical
starter until the latches click into place.
WARNING: Keep your hands away from the
starter bit to avoid injury.
3. Lay the product on the ground, and make
sure that the cutting means does not come in
contact with anything. Press the primer bulb
10 times.
NOTE: After the 7th press, the fuel should
be visible in the primer bulb. If not, continue
pressing until the fuel is visible.
Set the choke lever to position.
1
2
1
2
3
x10
1
2
15