Ryobi RBC254SESO Original Instructions Manual page 15

OPERATION
STARTING THE PRODUCT (COLD ENGINE)
1. Lay the product on the ground. Ensure that
the cutting means will not contact anything
when it starts to rotate. Press the primer bulb
10 times.
NOTE: After the 7th press, the fuel should
be visible in the primer bulb. If not, continue
pressing until the fuel is visible.
Set the choke lever to position.
2. Hold down the trigger lock and squeeze the
throttle trigger to operate the product. Pull
the starter grip until the engine attempts to
start. Do not pull the starter grip more than
4 times. Keep the throttle trigger squeezed
completely through step 4.
3. Set the choke lever to
starter grip until the engine starts. Do not pull
the starter grip more than 6 times.
NOTE: If the engine does not start, repeat
the procedure again from setting the choke
lever to position.
4. Allow the engine to run for 10 seconds, then
set the choke lever to
1
2
3
2
position. Pull the
3
position.
4
1
x10
1
1
2
1
2
4x
3
4 4 4
6x
4
6 6 6
2
13