Aiwa XR-MD85 Operating Instructions Manual page 2

Md/cd stereo system
Hide thumbs Also See for XR-MD85:
Table of Contents

Advertisement

WARNING
TO REDUCE
THE
RISK OF FIRE OR ELECTRIC
SHOCK,
DO NOT EXPOSE
THIS APPLIANCE
TO
RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
"CAUTION:TO REDUCE THE RISK OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL."
CAUTION
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation
exposure.
This compact disc player is classified as
a CLASS
1 LASER
product.
The CLASS 1 LASER PRODUCT label is located on the exterior.
CLASS 1
LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS
1
LASER APPARAT
CAUTION!
Invisible laser radiation when open and interlocks
defeated.
Avoid exposure to beam.
ADVARSEL!
Usynlig laserstaling ved abning, nar sikkerhedsafbrydereer ude af
funktion. Undga udszettelse for straling.
VAROITUS!
Laitteen kayttaminen muulla kuin tassa kayttéohjeessaa mainitulla
tavalla saattaa altistaa kayttajan turvallisuusluokan 1 ylittavalle
nakymatt6émalle lasersateiylle.
VARNING!
Om apparaten anvands pa annat s&tt 4n i denna bruksanvisning
specificerats, kan anvandaren utsatta for osnylig laser-straining,
som 6verskrider gransen fér laserklass 1.
1 ENGLISH
PREPARATIONS
PRECAUTIONS
Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions for
future reference.
All warnings and cautions in the Operating
Instructions and on the unit should be strictly followed, as well as
the safety suggestions below.
Installation
1 Water and moisture — Do not use this unit near water, such as
near a bath, sink, swimming pool, or the like.
2 Heat — Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C or
greater than 35°C.
3 Mounting surface — Place the unit on a flat, even surface.
4 Ventilation —The unit should be situated with adequate space
around it so that proper heat ventilation is assured. Allow
10cm
clearance from the rear and the top of the unit, and 5 cm from
the each side.
- Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight rack
where ventilation may be impeded.
5 Objects and liquid entry
— Take care that objects or liquids do
not get inside the unit through the ventilation openings.
6 Carts and stands — When placed or mounted on a stand or
cart, the unit should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause
the unit or cart to overturn or fall.
7 Condensation — Moisture may form on the CD pickup Jens
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours, then
try to operate again.
8 Wailor ceiling mounting — The unit should notbe mounted on
a wall or ceiling, unless specified in the Operating Instructions.
Electric Power
1 Power sources — Connect this unit only to power sources
specified in the Operating Instructions, and as marked on the
unit.
2 AC power cord
- When disconnecting the AC power cord, pull it out by the
AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this
could result in fire or shock.
- Power cords should be firmly secured to avoid being severely
bent, pinched, or walked upon.
Pay particular attention to
the cord from the unit to the power socket.
- Avoid overloading AC power plugs and extension cords
beyond their capacity, as this could result in fire or shock.
3 When not in use — Unplug the AC power cord from the AC
outlet if the unit will not be used for several months or more.
When
the cord is plugged in, a small amount
of current
continues to flow to the unit, even when the power is turned off.
Maintenance
Clean the unit only as recommended in the Operating Instructions.
Damage Requiring Service
Have the units serviced by a qualified service technician if:
- The AC power cord or plug has been damaged
- Foreign objects or liquid have got inside the unit
- The unit has been exposed to rain or water
- The unit does not seem to operate normally
+ The unit exhibits a marked change in performance
- The unit has been dropped, or the cabinet has been damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.

Advertisement

Table of Contents
loading

Table of Contents