Table of Contents
Advertisement
OTHER FUNCTIONS OF RDS CODES
Auto EQ function
The equalization curve is switched automatically to match the
music program type of an RDS station.
To activate the auto EQ function, press the DEMO/RDS button
repeatedly until "A-EQ OFF" appears on the display.
Then turn the MULTI JOG dial right or left so that "A-EQ ON" is
displayed.
To cancel, repeat the above operation so that "A-EQ OFF" is
displayed.
The equalizer of this unit corresponding to PTY:
Equalizer of this unit
POP M, COUNTRY, NATION M,
OLDIES
CLASSICS, LIGHT M, JAZZ,
FOLK M
OFF
others
The selected equalizer can be changed to suit your preference
by pressing the EQ button on the remote control or using the
MODE button and the MULTI JOG dial (as described on page
6).
When you change the equalizer manually, the auto EQ function
is deactivated.
Clock-time (CT)
The CT function provides the unit with information about the local
time. The CT function works whenever a CT station is received.
lf you have not set the clock (the clock flashes on the display),
the current time is set automatically by tuning in to an RDS
station.
If no RDS station is preset, keep the << or
button pressed
until RDS lights up.
If the clock does not agree with the broadcast time, an RDS
signai will update the clock time on the hour every hour.
> Program type identification (PTY)
PTY allows selection of listening by one of 15 or more
program types rather than by a siation.
"6 Enhanced other networks (EON) information
EON information gives the receiver a cross reference to other
stations and allows the receiver to switch from the currently
tuned station to another RDS station.
'7 Traffic program identification (TP)
This is a code which informs the receiver that a tuned station
regularly broadcasts traffic information.
*8 Clock-time (CT)
CT function provides an accurate clock signal which is self
adjusting to time zones and seasonal time changes.
To change the MW tuning interval
The default setting of the MW- tuning interval is 9 kHz/step.
If
you use the unit in an area where the frequency ailocation system
is 10 kHz/step, change the tuning interval.
While pressing the TUNER/BAND
button, press the POWER
button.
To reset the interval, repeat this procedure.
When the MW tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
ENGLISH 10
Advertisement
Table of Contents
