Yamaha MOTIF RACK ES Owner's Manual page 67

KeyReset Key On Reset
Phase Phase
Delay Delay
FadeIn Fade In
Hold Hold
FadeOut Fade Out
Dest1-3ElmSw LFO Destination Element
Switch
Dest1-3Dest LFO Destination
Dest1-3Depth LFO Depth
Determines whether or not the LFO is reset each time a Note On message is received. The following three
settings are available.
Settings: off, each-on, 1st-on
off..................... The LFO cycles freely with no note synchronization. Receiving a Note On message starts the LFO wave at
whatever phase the LFO happens to be at that point.
each-on ........... The LFO resets with each Note On message and starts a waveform at the phase specified by the Phase
parameter (below).
1st-on .............. The LFO resets with every note you play and starts the waveform at the phase specified by the Phase
parameter (below). However, if you play a second note while the first is being held, the LFO continues cycling
according to the same phase as triggered by the first note. In other words, the LFO only resets if the first note
is released before the second is played.
off each-on
Time
Note On Note On
(first note)
Determines the starting phase point
for the LFO Wave when it is reset.
Settings: 0, 90, 120, 180, 240, 270
Determines the delay time between the moment that a Note On message is received and the moment the
LFO comes into effect. A higher value means a longer delay time.
Settings: 0 ~ 127
Determines the amount of time for the LFO effect to fade in (after the Delay time has elapsed). A higher
value means a slower fade-in.
Settings: 0 ~ 127
Low Fade In value
(faster fade-in)
Fade In
Max
Delay
Note On
Determines the length of time during
which the LFO is held at its
maximum level. A higher value
means a longer Hold time. When
sets to "127," the wave cannot be
faded out (below).
Settings: 0 ~ 127
Determines the time taken for the LFO effect to be faded out (after the Hold time has elapsed). A higher
value means a slower fade-out.
Settings: 0 ~ 127
Low Fade Out value
(faster fade-out)
Fade Out
Hold
Max
Determines whether to allow variations in the LFO Wave for each Element. The Element number (1- 4) is
shown when the LFO is enabled; a dash (-) indicates the LFO is disabled for that Element.
Determines the parameters which will be controlled.
Settings: amd, pmd, fmd, reso (resonance), pan, ELFOSpd (Element LFO Speed)
Determines the LFO Wave Depth.
Settings: 0 ~ 127
Voice mode
1st-on
Time
Note On Note On
(second note) (first note)
Phase 0 90 180 270
120 240
High Fade In value
(slower fade-in)
Fade In
Max
Time
Delay
Note On
Hold
Max
High Fade Out value
(slower fade-out)
Hold
Max
Time
Voice Edit (for Normal Voice)
Time
Note On
(second note)
Time
Time
Time
Fade Out
Time
67
Owner's Manual