Using Performance Effects - Yamaha MOTIF RACK ES Owner's Manual

Using Performance effects

In the final stages of programming, you can set the effects
parameters to further change the sound's character. In the
Performance Mode, you can set up and store the effects with each
Performance. For details on the structure of the effects, see
page 59.
Here we'll show an example of editing effect settings in the
Performance mode.
1.
Select the Performance you wish to edit (page 30).
2.
Press the [EFFECT] button once or twice to enter the
Effect Connection Edit mode.
The [EFFECT] button LED lights and the following display is
shown.
The selected parameter name and value are shown.
Insertion
Effects
Insertion Effects Selects the desired Part(s) to which the
Insertion Effects are to be applied. The Insertion
Effect settings depend on the settings of the
Voice assigned to each Part (made in the Voice
mode; page 29).
System Effects (Reverb, Determines the Type and Send/Return Level of
Chorus) System Effect (Reverb/Chorus).
3.
Select the desired Part(s) to which the Insertion Effects
are to be applied.
Set the checkbox(es) of desired Part(s) applied the Insertion
Effects to on, and set the rest of the Part(s) to off in the above
display. Move the cursor with the cursor [L][M] or PAGE [E][F]
buttons to the desired check box, then set the parameter to "on" or
"off."
4.
Set the System Effects (Reverb/Chorus).
Select the parameters in System Effects above with the cursor
[L][M] or PAGE [E][F] buttons, and then change the settings by
the data dial.
First select the Reverb/Chorus Type, then set the Send Level and
Panning. The following parameters are used to edit the System
Effect.
n For information on the Reverb/Chorus Types, refer to the separate Data
List.
n The Insertion Effect settings depend on the settings of the Voice assigned
to each Part (made in the Voice mode; page 29).
ReverbType (Reverb Type) For setting the Reverb Effect Parameters.
ReverbRtn (Reverb Return)
ReverbPan (Reverb Pan)
ChoCtgry (Chorus Category) For setting the Chorus Effect Parameters.
ChoType (Chorus Type)
ChoRtn (Chorus Return)
ChoPan (Chorus Pan)
ChoToRev (Chorus to Reverb) For adjusting the Send Level from the
Chorus Effect to Reverb Effect.
5.
Press the [EFFECT] button to enter the Effect Parameter
Edit mode.
You can edit detailed parameters from this display.
The PAGE [E][F] buttons can be used to switch between Effect
Types.
Select the desired parameter for editing by using the cursor [L][M]
buttons and change the settings with the data dial.
n The available parameters differ depending on the selected Effect Type.
n If "off" is selected for the effect type, none of the effect parameters can be
6.
As necessary, set the Master Effect or Master Equalizer
in the MEF or MEQ display.
[SHIFT] + [PERFORM]
mode by pressing [EDIT] once or twice
System Effects
MEQ display
(Reverb, Chorus)
For details on the structure of the effects, see page 59.
n When setting the Master Effect, make sure to turn Master Effect on. (Press
7.
Store the edited Performance.
If you wish to save the new settings, store the settings with the
other Performance Edit parameters as a single Performance
before you leave the selected Performance.
For details about storing Performances, see page 49.
CAUTION
If you call up another Performance or another mode without saving, the
edited settings may be lost.
Performance mode
Effect Type (Rev, Cho)
For details, refer to the separate Data List booklet.
edited.
select Performance
[SHIFT] + [COMMON]
the [SHIFT] + [BYPASS], then turn "Master" parameter to "effect on")
Using Performance effects
select Performance Edit
MEF or
35
Owner's Manual