Table of Contents
Advertisement
Trip computer
Introduction
The trip computer gives you information on
current and average fuel mileage, average
speed, fuel range and driving time .
Fig. 8 Trip compute r 1
The fo ll ow ing informa t ion is cont inuo usly
evaluated by t he trip compu t er and can be dis -
played sequentia lly in the instrument cluster
display:
Fuel range
The estimated cruising range in miles (km)
appears in the display. The disp lay changes in
increments of 6 miles (10 km) .
Average fuel mileage
The average fue l economy in MPG (l/ 100 km)
since you last cleared the memory appears in
t his display .
Current fuel mileage
The instantaneous fuel consumption in miles
per gallon (l/ 100 km) is shown in this display.
When the vehicl e is stationary, the most re-
cent fuel consumpt ion is displayed.
Average speed
The average speed in mph (km/h) since the
last time the display was reset appears in the
display.
Elapsed t ime
The length of time that you have been driving
since you last reset the memory appears in
this display . The maximum t ime period that
can be recorded is 999 hours and 59 minutes .
Dr iv er in f ormation
system
21
Distance
The elapsed dista nce since the last t ime the
memory was cleared appears in the display.
The maxim um distance that can be recorded
is 9,999.9 miles (9,999 .9 kilometers) .
(D
Tips
- Fuel consump t ions (average and cur-
rent), range and speed are disp layed in
metric un its on Canadian mode ls.
- All sto red val ues wil l be lost if t he vehi-
cle battery is disconnected .
'
.
Memories
The trip computer is equipped with two fully
automatic memories as well as on efficiency
progrom.
Fig. 9 Trip computer display: memo ry level 1
You can switch between the trip computer 1
and 2 by pressing the
I
RESET
I
but t on ®
q page 22, fig . 10 .
You can tell wh ich memory level is currently
active by the number or the sign in the display
Q
fig.
9 . The data from the single-trip memo-
ry (memo ry level 1) is being displayed if a
1
appea rs in t he display . If a 2 is shown, then
the data from the total- tr ip memory is being
displayed (memory level 2).
Single-trip memory (Trip computer 1)
The sing le-trip memory stores the tr ip info r-
mation from the time the ign it ion is tu rned on
unt il it is tu rned off . If the tr ip is cont inued
with in 2 hours from t he t ime the ignition was
tu rned off, the new data will be included in
.,..
Advertisement
Table of Contents
