Table of Contents
Advertisement
20
Dr iv e r in f ormation
sy s tem
Trip computer
Introduction
The trip computer gives you information on
current and average fuel mileage, average
speed, fuel range and driving time .
f
· + ss ~ F .
0
31.7MP G
Fig. 9 Trip computer 1
The follow ing information is cont inuously
evaluated by the trip computer and can be dis-
played sequentially in the instrument cluster
display:
Fuel range
The estimated cruising range in miles (km)
appears in the display. The disp lay changes in
increments of 6 miles (10 km) .
Average fuel mileage
The average fuel economy in MPG (l/100 km)
since you last cleared the memory appears in
this display .
Current fuel mileage
The instantaneous fuel consumption in miles
per gallon (l/100 km) is shown in this display.
When the veh icle is stationary, the most re-
cent f uel consumpt ion is displayed .
Average speed
The average speed in mph (km/h) since the
last time the display was reset appears in the
display.
Elapsed time
The length of time that you have been driving
since you last reset the memory appears in
this display . The maximum time period that
can be recorded is 999 hou rs and 59 minutes .
Distance
The elapsed dist ance since the last time the
memo ry was cleared appears in the display.
The maxim um distance that can be recorded
is 9,999 .9 miles (9,999.9 kilometers) .
a)
Tips
- Fuel consumptions (average and cur-
rent), range and speed are displayed in
metric units on Canadian mode ls.
- All stored values will be lost if the vehi-
cle battery is disconnected.
Memories
The trip computer is equipped with two fully
automatic memories as well as an efficiency
program.
Fig. 10 Trip compute r display: memory level 1
You can switch between the trip computer 1
and 2 and the effic iency program* by pressing
the
IRES ET I
button @
Qpage 21, fig . 11 .
You can tell wh ich memory level is currently
active by the number or the sig n in the display
¢
fig. 10 .
The data from the single-t rip mem-
ory (memory level 1) is being displayed if a
1
appears in the display . If a 2 is shown, then
t he dat a from the t ota l-t rip memory is being
displayed (memory level 2). The f uel pump
nozzle
ii
indicates the efficiency program *
¢ page 23.
Single-trip memory (Trip computer 1 )
The sing le-t rip memory stores the tr ip infor -
mation from t he time the ign it ion is tu rned on
unt il it is turned off.
If
t he trip is cont inued
with in 2 hours from the time the ignition was
turned off, the new data will be included in
..,.
Advertisement
Table of Contents
