Table of Contents
Advertisement
92
Hom e lin k®
may not be sufficient for the Homelink ® sys-
tem to learn the radio frequency signal. Per-
form all other steps as described above .
Operating the Homelink ® transmitter
The HomeLink® transmitter works in the
some manner as the original hondheld re-
mote control that come with the system.
Fig. 101
Overhead conso le: Home l ink® keypad
.,. Press the appropriate programmed button
(D,
®
or @) to activate the des ired remote
control funct ion
c::>
&,
in General informa-
tion on page 90.
Reprogramming a single button
A Homelink ® button can be reprogrammed
individually without affecting the other but-
ton allocations.
Programming the overhead keypad
.,. Press the appropriate Homelink ® button un -
t il the indicator light begins flashing slowly .
Programmin g the bumper mounted tran s
mitter
1.
Hold the
original remote control
at a dis -
tance between 0- 5 in. (0- 13 cm) from the
bumper below the appropriate head light
for your vehicle (use the shortest distance
possib le).
2. Aim the remote control just below the
driver side
headlight .
3 . Press and hold the activation button on
the remote control.
4 . The emergency flashers will flash
th ree
time s
(after about 15- 60 seconds) when
the programming is successful. Now re-
lease the button on the remote control.
.,. If the device utilizes a rolling code, please
follow phase 3 of
c::>
page 90, Programming
the HomeLink® transmi t ter
for rolling code
programm ing .
This procedure will cause the existing pro-
gramm ing on the Homelink ® button to be
erased!
Erasing the programming of the
Homelink ® transmitter
When you erase the programming , the pro-
gramming on all three of the transmitter
channels with be lost!
.,. Perform steps 1 to 4 as described on
c:::;,
page 91, Phase 1: programming the over-
head keypad .
When completed , the Homelink ® system will
be in the programming mode and is then
ready to learn the codes fo r remote controlled
devices.
©
Tips
- Programmed buttons cannot be erased
ind ividually .
- For security reasons you are advised to
erase the programming of the Home-
Link® system before you se ll your vehicl e .
Advertisement
Table of Contents
