Performing Initial Setup Operations - Sony STR-DE675 Operating Instructions Manual

Performing Initial Setup Operations
z
o
o
5'
C
5'
C
"0
3
Once you have made speaker connections and have
turned on the power for the first tilne, clear the receiver's
memory. After you have done this, set the speaker sizes,
speaker locations and other initial system settings that are
necessary.
Before you use your receiver for the first time or when
you want to clear the receiver's memory, do the fk_llowing.
If the Demonstration appears when the power is turned
on, this procedure is not necessary.
t_=..o t...=_o
1
Turn off the receiver.
2
Hold down I/_) for four seconds.
The currently selected function, then the
demonstration message appears in the display and the
items including the following are reset or cleared:
• All preset stations are reset or cleared.
• All sound field parameters are reset to their factory
settings.
• All index names (of preset stations and program
sources) are cleared.
• All adjusmmnts made with the SET UP button are
reset to their factory settings.
• The sound field memorized for each program source
and preset stations are cleared.
Befk)re you tlse your receiver for the first time, tlse the SET
UP button to adjust settings to correspond to your system.
You can set the following items. For details on how to
adjust each setting, see the page in parentheses.
• Set the speaker size (page 17).
• Set the speaker distance (page 19).
• Select the MULTI CH IN video signal (page 45).
• Whether the display turns off or not when you press
DIMMER (page 45).
Demonstration Mode
The demonstration will activate the first time you turn on the
power. When the demonstration starts, the following message
appears in the display :
"NOW DEMONSTRATION MODE IF YOU FINISH
DEMONSTRATION PLEASE PRESS POWER KEY
WHILE THIS MESSAGE APPEARS IN THE DISPLAY
THANK YOU"
To cancel the demonstration
Press I/(_ to turn the receiver offwhile the above message is
being displayed. The next time you turn the receiver on, the
demonstration will not appear.
To view the demonstration
Hold down SET UP and press I/_) to turn on the power.
Notes
• Running the demonstration will clear the receiver's
memory. For details on what will be cleared, see "Clearing
the receiver's memory" on this page.
• There will be no sound when the demonstration mode is
activated.
• You cannot cancel demonstration if you did not press I/_)
while the above message is being displayed. To cancel
demonstration after the above message appears, press I/_)
twice to activate the demonstration again. Then, press I/_)
while the above message is being displayed.
16