Super Knob Motion Sequence Edit - Yamaha MONTAGE M6 Operation Manual

Super Knob Motion Sequence Edit

The setting screen for the Super Knob Motion Sequencer.
You can create a sequence of up to 16 steps.
Loop Start (Super Knob Motion Sequencer Loop Start)
Specifies the starting point for the loop playback of the Motion Sequence.
Settings: 1–16 (should be below the Length setting)
Length (Super Knob Motion Sequence Length)
Sets the Motion Sequence length.
Settings: 1–16 (should be above the Loop Start setting)
MS Grid (Super Knob Motion Sequence Grid)
Sets the length of a step in the Motion Sequence (as a note value).
Settings: 60, 80, 120, 160, 240, 320, 480
Sequence Select (Motion Sequence Select)
Changes the Motion Sequence type selection.
Settings: 1–8
Polarity (Super Knob Motion Sequence Polarity)
Sets the polarity of the Motion Sequence.
Settings: Unipolar, Bipolar
Unipolar: Only positive values are used for the parameter change.
Bipolar: Both positive and negative values are used for the parameter change.
Amplitude (Super Knob Motion Sequence Amplitude)
129