Edit Mode - Yamaha DX9 Operating Manual

EDIT MODE
e EDIT MODE .... Creating Voices
[he EDIT mode can be used to edit pre-programmed
voices or to create entirely new voices. Press the [EDIT/
COMPARE] function key to enter the EDIT mode.
Edit Mode Parameter
WAVE SPEED DELAY
MODE SAVE /VERIFY LOAD
PORTAMENTO CASSETTE
EG KEYBOARD SCALING
o d
w |" о LEVEL
EG BIAS RANGE PITCH E EG BIAS
BREATH CONTROL
Setting and modifying parameters is carried out using the
DATA ENTRY controls just as in the FUNCTION mode.
A small dot will appear next to the voice number in the
display if any data is modified. The original voice can be
recalled at any time while editing by pressing the
key again. The voice number will
flash indicating that you are hearing the original voice.
To continue editing press the button
again.
Now for an explanation of the DXQ's functions and opera-
tion.
ө The indicators display for EDIT mode
The number of the al-
gorithm which is being
used for that particular
preset voice
Display the current
state of the operators
from OP1 through OP4
begining at the left
Voice
number
The dot will appear
when any data has
been modified.
The operator selected
will be displayed only
for the parameters that
can modified
Displays each
parameter
e OPERATOR ON-OFF/EG COPY
OPERATOR ON-OFF/EG COPY
1 2
3 4
In the EDIT mode these keys permit turning any of the
operators on or off, and copying the EG data of any
operator to any other operator (EG COPY).
OPERATOR ON-OFF:
Pressing keys through [4] will result in the
corresponding operator being turned OFF, indicated by a
"O' in the appropriate location on the display panel (the
group of four 1's and/or 0% corresponds to operators 1
through 4). Press the key again to turn the operator back
on-indicated by а "1" on the display.
1: Signifies that the operator is activated
0: Signifies that the
x operator is disabled
—^——
ALG 4 1108 ОР2
RATE SCALING = ü
* No sound will be produced
if the carrier operators
have all been disabled.
EG COPY:
This function copys the EG data from one operator to
another. While holding the selector key, press
the number of the operator from which you want to
copy EG data.
The display pane! when the
Store key has been pressed.
While pressing
STORE
XN key, | `
1 4
с press the key for the operator
1 ~ |4 M Сх number that you wish to copy.
KA
Eo.
This signifies that the
EG COPY EG data of OP2 are
from ОР? to СІРІ being copied to OP1.
* ALGORITHM / FEEDBACK
Pressing this key alternately switches to ALGORITHM
and FEEDBACK.
ALGORITHM
/FEEDBACK
ALGORITHM:
This key permits selection of one of the 8 algorithms.
Press the DATA ENTRY key to increment (advance)
the number of the selected algorithm, and the key
to decrement the algorithm number. The slide control
can be used for lager variations.
This value wil! change,
ГА
HLG 1 1188
ALGORITHM SELECT