Yamaha MONTAGE M6 Operation Manual page 255

Operation
[PERFORMANCE] → Part Common selection → [EDIT/ ] → General/Pitch → Zone
Settings
Keyboard Sw (Keyboard Control Switch)
Keyboard Control is used for selecting Parts to be played from the keyboard.
When this switch is set to On, you can simultaneously play all Parts having Keyboard Control
set to On, if the Part is set to Common or Keyboard Control for the Part is set to On.
When Keyboard Control is set to Off, you can play the Part on the keyboard only when that Part
is selected.
Settings: Off, On
Zone Vel Limit (Zone Velocity Limit)
Sets the velocity range (lowest and highest values) for the Zone.
When this is set so that the higher value is first and the lower value is second (for example, 93
to 34), the notes are played only for velocities of 1 to 34 and 93 to 127.
Settings: 1–127
Zone Note Limit
Sets the note range (lowest and highest notes) for the Zone.
When the first note of Note Limit is set higher than the second (for example, C5 to C4), the
notes in the ranges C−2 to C4 and C5 to G8 will be played.
Settings: C−2–G8
Octave Shift
Shifts the pitch of the zone in octaves.
Settings: −3–+0 (standard)–+3 (in octaves)
255