Cub Cadet 7530 Operator's Manual page 65

THREE POINT HITCH SYSTEM
The three point hitch system gives position control and draft control (If
equipped) of implements. This tractor is equipped with a category I hitch.
The three-point hitch dimensions are shown in the following table.
Implement Identification
Dimensions
A – Gap in top of implement mast
B – Diameter of holes in top of
Implement mast
C – Diameter of hitch pins
D – Lower Hitch Pin
Inner Shoulder Spread
Implement
44.5 mm (1-3/4 inch)
19.1 mm (3/4 inch)
22.2 mm (7/8 inch)
682.6 mm (26-7/8 inch)
57
FIELD OPERATION
Cat I