Cub Cadet 7530 Operator's Manual page 47

STEP 3
Put the REAR PTO and MID PTO
c o n t r o l l e v e r s i n t h e O F F
(Engine start) position.
STEP 4
Put the SHUTTLE lever in the N
(Engine start) slot (Gear Drive).
HST control pedal in the N position
CLUTCH pedal (HST Drive)
STEP 5
OFF OFF
POSITION POSITION
Put the engine speed control lever
at the middle position.
STEP 6
Turn the starter key switch to the
heat & ON position.
Wait until the glow plug indicator lamp
is put out.
(Approximately 1 to 3 seconds.)
39
OPERATING INSTRUCTION
ENGINE ENGINE
SPEED SPEED
CONTROL CONTROL
LEVER LEVER