Cub Cadet 7530 Operator's Manual page 57

POWER TAKEOFF (PTO)
PTO driven machinery can cause serious injury or death, usually due
to wrapped clothing. When required by the job to be in the
drive shaft area, stay clear of rotating parts. Before working on the
drive shaft, or servicing or clearing the driven machine, where
applicable on this tractor, put the PTO clutch lever in the DISENGAGE
position, the PTO lever in the NEUTRAL or OFF, and STOP the engine.
Rear PTO (HST)
The rear PTO is a 540 RPM with a
34.9 mm (1 3/8 inch) diameter 6
spline output shaft.
ENGAGE THE REAR PTO AS
FOLLOWS:
1. Push the clutch pedal fully.
2. Move the PTO control lever to the
ON position.
3. Release the clutch pedal slowly.
DISENGAGE THE REAR PTO
AS FOLLOWS:
1. Push the clutch pedal fully.
2. Move the PTO control lever to the
OFF (Engine Start) position.
NOTE : Keep the PTO control lever
in the OFF (Engine Start) position
when starting the engine and when
the PTO is not being used.
3. Release the clutch pedal slowly.
The following table shows the required speed to get the required Rear
PTO output shaft speed.
REAR PTO REAR PTO REAR PTO
CONTROL LEVER CONTROL LEVER CONTROL LEVER
PTO Output Required
Shaft Speed Engine Speed
540 RPM 2376 RPM
49
OPERATING INSTRUCTION
REAR PTO SHAFT REAR PTO SHEFT REAR PTO SHEFT
CLUTCH PEDAL
CLUTCH PEDAL CLUTCH PEDAL