Cub Cadet 7530 Operator's Manual page 100

Fuel Filter Element Replacement
To replace the filter element, use following procedure:
STEP 1
FUEL SHUT-OFF VALVE
CLOSE
Close the fuel shut-off valve.
STEP 2
Clean the outside of the filter body
and cup to prevent dirt or foreign
materials from entering the system.
STEP 3
Loosen the filter cup-retaining nut.
Remove filter cup. Remove old filter
element and clean inside of filter cup.
STEP 4
Install new filter element. Assemble
filter cup and retaining nut to filter body.
NOTE: Be sure O-ring is in place on
the filter body and filter cup.
STEP 5
Open the fuel shut-off valve and vent
the fuel system. See Fuel System
RETAINING NUT
Air removal in this manual.
STEP 6
Clean fuel off the engine. Start the
engine to check for fuel leaks around
the filter, lines and fittings.
NOTE: If the engine does not have
power with a full load after you have
done the filter service and removed
the air from the system, see your Dealer
to find and correct the cause.
92
LUBRICATION/FILTERS/FRUIDS
FILTER ELEMENT
OPEN