Maintenance/Adjustments - Cub Cadet 7530 Operator's Manual

RAISE STOP SETTING POSITION
HITCH CONTROL HITCH CONTROL HITCH CONTROL
LEVER LEVER LEVER
1. Disconnect an implement from the hitch. (See Disconnecting Implement
from Hitch in this manual.)
2. Disconnect LH and RH lifts rods from the lift arms.
3. Start the engine.
Rotating fan and belts. Contact can injure. Keep clear.
4. Move the hitch control lever rearward to raise the lift arm to the
maximum lifting position.
5. With the arm so raised, stop the engine.
6. Check a free play of the lift arm to be 5 to 10 mm at the tip of the lift
arm by hands.
7. If the insufficient free play is available, move the raise stop forward
and check again with the same procedure as before.

MAINTENANCE/ADJUSTMENTS

If raise stop setting position is incorrect,
the hydraulic pump might be damaged.
Therefore carefully adjust as below.
RAISE
STOP
109