Table of Contents
Advertisement
Figure 47. Installing the heat sink
Steps
1. Place the heat sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (1 > 2 > 3 > 4 > 5 > 6 > 7) tighten the seven captive screws that secure the heat sink to the system
board.
Next steps
1. Install the
base cover for computers shipped with an aluminum
2. Follow the procedure in
Power-adapter port
Removing the power-adapter port for computers shipped with a
plastic chassis
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see,
2. Remove the
base cover for computers shipped with a plastic
74
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
chassis.
computer.
computer.
chassis.
Before working inside your
computer.
Advertisement
Table of Contents
