Table of Contents
Advertisement
Installing the palm-rest and keyboard assembly for computers
shipped with an aluminum chassis
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the
installation procedure.
Figure 109. Installing the palm-rest and keyboard assembly
Steps
Place the palm-rest and keyboard assembly on a clean and flat surface.
Next steps
1. Install the
system board for computers shipped with an aluminum
2. Install the
display assembly for computers shipped with an aluminum
3. Install the
touchpad for computers shipped with an aluminum
4. Install the
power button with fingerprint reader for computers shipped with an aluminum
5. Install the
heatsink for computers shipped with an aluminum
6. Install the
fan for computers shipped with an aluminum
7. Install the
speakers for computers shipped with an aluminum
8. Install the
I/O board for computers shipped with an aluminum
9. Install the
M.2 2230 solid-state drive for computers shipped with an aluminum
138
Removing and installing Field Replaceable Units (FRUs)
chassis.
chassis.
chassis.
chassis.
chassis.
chassis.
chassis.
chassis.
chassis.
Advertisement
Table of Contents
