Table of Contents
Advertisement
About this task
The following image indicates the location of the system fan and provides a visual representation of the installation procedure.
Figure 33. Installing the fan
Steps
1. Place the fan on the palm-rest and keyboard assembly.
2. Align the screw holes on the fan with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x4) that secure the fan to the palm-rest and keyboard assembly.
4. Connect the fan cable (FN1) to the system board.
Next steps
1. Install the
base cover for computers shipped with a plastic
2. Follow the procedure in
Removing the system fan for computers shipped with an aluminum
chassis
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in,
computer.
2. Remove the
base cover for computers shipped with an aluminum
About this task
The following image indicates the location of the system fan and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
chassis.
computer.
computer.
chassis.
Removing and installing Customer Replaceable Units (CRUs)
Before working inside your
59
Advertisement
Table of Contents
