Table of Contents
Advertisement
The following image indicates the location of the power-adapter port and provides a visual representation of the removal
procedure.
Figure 50. Removing the power adapter port
Steps
1. Remove the two screws (M2.5x4.5) that secure the right hinge to the palm-rest and keyboard assembly.
2. Rotate to open the right hinge.
3. Peel the tape that secures the power-adapter cable to the system board and disconnect the power-adapter cable from the
connector (DC IN1) on the system board.
4. Lift the power-adapter port off the palm-rest and keyboard assembly.
Installing the power-adapter port for computers shipped with an
aluminum chassis
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
77
Advertisement
Table of Contents
