Power-Adapter Port; Removing The Power-Adapter Port - Dell Inspiron 16 Plus 7640 Owner's Manual

Figure 51. Installing power button
Steps
1. Place the power button into its slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power button to the screw hole on the palm-rest and keyboard assembly.
3. Replace the tape that secures the fingerprint-reader cable to the palm-rest and keyboard assembly.
NOTE: This step is only applicable for computers that are shipped with the power button with an optional fingerprint
reader.
Next steps
1. Install the I/O board.
2. Install the heat sink.
3. Install the base cover.
4. Follow the procedure in

Power-adapter port

Removing the power-adapter port

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in
computer.
2. Remove the base cover.
3. Remove the heat sink.
76 Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Before working inside your