Table of Contents
Advertisement
Next steps
1. Install the
system
board. (only applicable when the touchpad cable has been replaced)
2. Install the
right
I/O-board. (only applicable when the touchpad cable has been replaced)
3. Install the battery.
4. Install the
rear
I/O-cover.
5. Install the
2230 solid-state
6. Install the
2280 solid-state
7. Install the
base
cover.
8. Follow the procedure in
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
2230 solid-state
4. Remove the
2280 solid-state
5. Remove the
rear
I/O-cover.
6. Remove the battery.
7. Remove the
right
I/O-board.
8. Remove the
system
board.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the removal procedure.
Steps
1. Remove the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.
2. Lift the power-adapter port bracket off the palm-rest assembly.
3. Lift the power-adapter port along with its cable off the palm-rest assembly.
50
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
drive. (if applicable)
drive. (if applicable)
computer.
computer.
Advertisement
Table of Contents
