Installing the power button with fingerprint reader
About this task
The following image indicates the location of the power button with fingerprint reader and provides a visual representation of
the removal procedure.
NOTE:
Steps
1. Affix the power button cable with adhesive backing.
2. Align and place the power button with fingerprint reader into the slot on the palmrest assembly.
Next steps
1. Install the
ethernet
port.
2. Install the
I/O
board.
3. Install the
base
cover.
4. Exit the
service mode
5. Install the
SIM card tray
6. Install the microSD-card.
7. Follow the procedure in
System board
Removing the system board - for computers with discrete graphics
card
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Remove the
SIM card tray
4. Remove the
base
cover.
5. Remove the battery.
for 4G LTE enabled systems.
after working inside your
before working inside your
for 4G LTE enabled systems.
computer.
computer.
Removing and installing components
69