Heat-Sink Assembly; Removing The Heat-Sink Assembly - For Computers Shipped With An Integrated Graphics Card - Dell XPS 14 9440 Owner's Manual

Steps
1. Adhere the M.2 SSD thermal pad if it is detached from the system board during the removal process.
2. Align the notch on the M.2 2280 SSD with the tab on the SSD slot.
3. Slide and place the M.2 2280 SSD on the thermal pad in the SSD slot.
4. Insert the tab of the M.2 SSD shield into the peg on the system board.
5. Replace the screw (M2x2.5) that secures the M.2 SSD shield to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in

Heat-sink assembly

Removing the heat-sink assembly - for computers shipped with an
integrated graphics card
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the base cover.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 51