The product has a grounded power cord and power
plug. Always connect the product to a grounded mains
outlet. This decreases the risk of electrical shock.
Do not use electrical adapters with the product.
Extension cables
•
Use only approved extension cables with applicable
properties.
•
The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
•
Use grounded extension cables.
•
When you operate the product outdoors, use
an extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
•
Keep the connection to the extension cable dry and
off the ground.
•
Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
•
Make sure that the extension cable is in good
condition and not damaged.
•
Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
•
Make sure that the extension cable is out of the
way and the product during operation. This prevents
damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
•
Do not use the product if the safety devices are
damaged or does not operate correctly.
•
Do a check of the safety devices daily. If your safety
devices are damaged or does not operate correctly,
speak to your Husqvarna service agent.
•
Do not make modifications on safety devices
ON/OFF switch
The ON/OFF switch is used to start and stop the power
supply to the product.
2335 - 001 - 14.12.2023
Read the warning
To do a check of the ON/OFF switch
1. Turn the emergency stop button (A) clockwise
to make sure that the emergency stop button is
disengaged.
2. Turn the ON/OFF switch to the ON position (B).
3. Make sure that the control light on the control panel
comes on.
4. Turn the ON/OFF switch to the OFF position (C).
5. Make sure that the control light on the control panel
goes off.
ON/OFF buttons of the drive motors
The ON/OFF buttons of the drive motors are used to
start and stop the drive motors. Refer to
of the drive motors on page 9 .
To do a check of the drive motors
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Set the ON/OFF switch to the ON position.
3. Push the ON button of the drive motors (A).
B
A
D
A
To do a check
B
C
C
9