Husqvarna EBE 350S Operator's Manual page 10

4. Make sure that the indicator for the drive motors
comes on (B).
5. Set the speed control to 1.
6. Push the 2 joysticks forward (C). Make sure that the
product operates forward.
7. Set the 2 joysticks to the neutral position. Make sure
that the product stops.
8. Pull the 2 joysticks rearward. Make sure that the
product operates rearward.
9. Set the 2 joysticks to the neutral position.
10. Push the OFF button of the drive motors (D).
11. Make sure that the indicatorfor the drive motors goes
out.
ON/OFF buttons of the fan unit
The ON/OFF buttons of the fan unit are used to start
and stop the fan unit. Refer to
ON/OFF buttons of the fan unit on page 10 .
To do a check of the ON/OFF buttons of the fan unit
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Set the ON/OFF switch to the ON position.
3. Push the ON button of the fan unit (A).
4. Make sure that the fan unit starts.
5. Push the OFF button of the fan unit (B).
6. Make sure that the fan unit stops.
ON/OFF buttons of the blast motor
The ON/OFF buttons of the blast motor are used to start
and stop the blast motor. Refer to
ON/OFF buttons of the blast motor on page 10 .
To do a check of the ON/OFF buttons of the blast motor
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Set the ON/OFF switch to the ON position.
10
To do a check of the
A
B
To do a check of the
3. Push the ON button of the blast motor (A).
4. Make sure that the blast motor starts.
5. Push the OFF button of the blast motor (B).
6. Make sure that the blast motor stops.
Ammeter
The ammeter shows the blast load onto the surface. The
maximum amperage is shown above the ammeter.
To do a check of the ammeter
Control panel on page 4 for information about
Refer to
where the ammeter is on your product.
1. Start the product. Refer to
page 16 .
2. Wait until the ammeter is in idle position.
3. Stop the product. Refer to
page 19 .
Emergency stop button
The emergency stop button is used to quickly stop the
motors.
To do a check of the emergency stop button
Refer to Control panel on page 4 for information about
where the emergency stop button is on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 16 .
3. Push the emergency stop button.
4. Make sure that the motors stop.
5. Turn the emergency stop button clockwise to
disengage.
A
B
To start the product on
To stop the product on
To start the product on
2335 - 001 - 14.12.2023