Husqvarna EBE 350S Operator's Manual page 119

WAARSCHUWING:
onderhoud uitvoert, moet u de motoren
stopzetten en de stekker van de voeding
loskoppelen. Controleer of alle aandrijvingen
stoppen.
Voor alle onderhouds- en reparatiewerkzaamheden
aan het product is speciale training nodig. Wij
garanderen de beschikbaarheid van professionele
reparaties en onderhoud. Indien uw dealer geen
servicewerkplaats heeft, vraag hem dan naar de
dichtstbijzijnde servicewerkplaats.
General product maintenance
Empty the dust collector.
Do a check of the of the sepa-
rator and the separator tray.
Make sure that the power plug
and extension cable are in
good condition and not dama-
ged.
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
Do a check of the Residu-
al Current operated Device
(RCD).
Examine the motors for dirt and
damage.
Make sure that the dust collec-
tor hose is not damaged and
that there is no blockage.
Do a check of the control ca-
ge and blast wheel blades for
Voordat u het
wear. Refer to
product gebruikt op pagina 110 .
Clean the product.
Do a check of all safety devi-
ces.
Do a check of the brush list
seals and the front rubber seals
for wear.
Do a check of the hydraulic
connections and hoses.
Do a check of the oil level.
Make sure that the nuts and
screws are tight.
2335 - 001 - 14.12.2023
Voordat u het
Each 3 h Daily
*
X
*
*
*
*
*
X
X
X
*
*
*
Zie www.husqvarnaconstruction.com voor meer
gedetailleerde informatie.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
12 h after ser-
vicing
*
Each 3
Yearly
months
119