Husqvarna EBE 350S Operator's Manual page 21

General product maintenance
Do a check of the V-belt ten-
sion.
Do a complete servicing and
cleaning of the product.
Replace the oil return filter and
the oil suction filter.
To do a check of the hydraulic hoses
• Examine the hydraulic hoses regularly. Replace
worn or damaged hydraulic hoses.
WARNING:
The rubber in the hydraulic hoses wears with
time. Worn or damaged hydraulic hoses can
break and the hydraulic oil can cause injury.
If you cannot tell if the hydraulic hoses are
worn, always replace the hydraulic hoses.
To do a check of the hydraulic oil level
• The hydraulic oil level must be in the middle of the
glass on the oil level indicator.
• Fill the hydraulic tank if the hydraulic oil level is too
To fill the hydraulic oil on page 21 .
low. Refer to
To fill the hydraulic oil
1. Park the product on level ground.
2335 - 001 - 14.12.2023
Each 3 h
Hydraulic oil is dangerous.
12 h after
Daily
servicing
2. Remove the cap to the hydraulic oil tank.
3. Fill hydraulic oil in the hydraulic oil tank. Refer to
Technical data on page 30 for information about the
correct type of hydraulic oil.
4. Install the cap to the hydraulic oil tank.
5. Do a check of the hydraulic oil level. Refer to
check of the hydraulic oil level on page 21 .
To clean the product
• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To remove abrasive material from the
hopper
1. Start the product. Refer to
page 16 .
2. Push the ON button of the blast motor.
Each 3
Yearly
months
X
O
O
To do a
To start the product on
21