Husqvarna EBE 350S Operator's Manual page 15

3. Open the separator tray and remove all
contaminations when you fill abrasive material or
when it is necessary.
4. Fill the separator with abrasive material up to
the separator tray. Fill the separator with abrasive
material when it is necessary.
To connect a dust collector
WARNING:
collector if the dust collector hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust collector hose for damages.
2. Make sure that the filters in the dust collector are
clean and not damaged.
2335 - 001 - 14.12.2023
Do not use the dust
3. Attach the dust collector hose safely to the
connection for dust collector. Connect the dust
collector hose with hose clamps and industrial tape.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To do a check of the direction of
rotation of the fan unit
1. Start the product. Refer to
page 16 .
2. After some seconds, stop the product. Refer to
stop the product on page 19 .
3. Make sure that the fan unit has the correct direction
of rotation. The correct direction is shown with an
arrow on the fan unit cover.
4. If the fan unit does not have the correct direction of
rotation, change the phase sequence of the power
supply.
To select the correct speed
It is important to operate the product with the correct
speed for best result. If the surface has different quality,
adjust the speed for an equal result. Examine the result
and adjust the speed if it is necessary.
To start the product on
To
15