Husqvarna EBE 350S Operator's Manual page 24

4. Install the 2 screws, the 4 washers, the 2 cage
clamps and the control cage.
5. Install the hopper. Refer to
hopper on page 22 .
To remove the blast wheel blades
CAUTION:
blast wheel, it is necessary to replace all 6
blast wheel blades at the same time.
1. Remove the hopper. Refer to
the hopper on page 22 .
2. Remove the control cage and the impeller. Refer to
To remove the impeller on page 22 .
3. Lift the front part of the product and tilt the product
rearward.
WARNING:
product does not tilt forward.
24
To remove and install the
To prevent unbalance in the
To remove and install
Make sure that the
4. Use a brass drift and a hammer to push out the blast
wheel blades.
CAUTION:
the blast wheel blades. There is a risk
that the blast wheel blades will break.
5. Clean the blast wheel fully to make sure that the
blades and impeller will fit correctly and to prevent
unbalance of the blast wheel.
6. Replace all blades and install the machine in
opposite sequence.
To do a check of the V-belt tension
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
page 19 .
2. Remove the 3 screws, the 6 washers and the V-belt
cover.
3. Examine the V-belt for damages and wear.
Push at the bottom of
Do not operate the product
To stop the product on
2335 - 001 - 14.12.2023