Table of Contents
Advertisement
Malfunctions
The water is not drained
pumps.
There is no visible
water in the drum.
The wrong detergent
del/wrong fabric
softener is in the
dispenser(s) done.
Detergent/fabric softener
ter has solidified in the
dispenser(s).
Foam is leaking from the
detergent drawer.
Repeated, intensive
foaming.
Detergent/fabric softener
drips from the seal
and collects on the
door or in the fold of
the seal.
Cause/Solution
The drain pipe or water drain hose is clogged. Clean the drain pipe and the water
■
drain hose.
The drain pipe or water drain hose is jammed or closed. Make sure that
■
the drain pipe and the water drain hose are not kinked or pinched. The
drain pump is clogged.
■
~" The drain pump is clogged" on page 45
The drain hose at the siphon is clogged.
■
~" The drain hose at the siphon is clogged" on page 47
~~~ (Rinse hold = no final drain) is activated (depending on the
■
model). Resume the program by0[Spin/Drain to choose and
pressaStart/Refill to push.
The water drain hose is connected too high. Install the water
■
drain hose at a height of up to 1 meter.
~" Length of hoses and connection cable" on page 17
No interference: the water is below the visible area.
Empty the dispenser(s), clean them and fill them with the correct product.
~" Empty the detergent drawer, clean the detergent drawer and its
housing" on page 45
~" Filling with detergent and care agent" on page 39
Empty the dispenser(s), clean them and fill them with the correct product.
~" Empty the detergent drawer, clean the detergent drawer and its
housing" on page 45
~" Filling with detergent and care agent" on page 39
Used too much detergent?
Mix 1 tablespoon of fabric softener with ½ liter of water and pour into dispenser II.
(Not for outdoor or sportswear or down-filled textiles!)
Reduce the detergent dosage for the next wash.
Use a commercially available low foaming detergent and care
product that is suitable for the machine.
Have you used too much detergent? Use less detergent on the next
wash cycle with the same load.
There is too much detergent/fabric softener in the dispensers. Do not fill the
dispensers above themax. marking.
Malfunctions and how to fix them
NL
51
Advertisement
Table of Contents
