NL
Malfunctions and how to fix them
Display
H:95
alternates with
"Ÿš (End)
when the pro
gram is completed
H:32
alternates with
"Ÿš (End)
when the pro
gram is completed
Other Displays
Malfunctions and how to fix them.
Malfunctions
Water is leaking from the
appliance.
The door cannot be
opened.
The appliance does not fill
with water.
No detergent is
dosed.
The program does not start.
50
Cause/Solution
No water detected in the drying phase can lead to poor drying results.
~" The filter in the water supply is clogged" on page 47
The load imbalance detection system interrupted the spin cycle because
the laundry was unevenly distributed. Distribute small and large items of
laundry evenly in the drum.
Turn the program selector to From, wait five seconds and turn it back on.
When the display reappears, please contact customer service.
Cause/Solution
Fix or replace the drain hose correctly.
■
Tighten the screw fitting to the supply hose.
■
~~~ (Rinse hold = no final drain) is activated (depending on the
■
module). Resume the program by0[Spin/Drain to choose and
pressaStart/Refill to push.
The temperature in the drum is too high to open the door.
■
The safety function is activated. Stop program? The water
■
level in the drum is too high.
■
Can the door only be opened with the emergency release?
■
~" Emergency release" on page 48
The program does not
■
start? Is the tap turned on?
■
Could the filter in the water supply be clogged?
■
~" The filter in the water supply is clogged" on page 47
Note:
If an additional water filter is installed (depending on
the model), check it for contaminants and clean it if necessary
~separate installation and cleaning instructions for water filter.
Is the supply hose kinked or pinched?
■
Do you have the buttonaStart/Refill touched or ñ Ready in/Drying time
■
chosen?
Is the door closed?
■
Child lock activated? Deactivate the child lock. Shop mode
■
activated?When the displaya•<displays for 5 seconds after you
■
turn on the device, the device is in shop mode. Wait for the
display messagea•< disappears.Touch
aStart/Refill on and hold for at least 5 s. "" then appears on the display
panel. Turn the program selector toFrom. Now you have already
turned off the shop mode. You can now use the device as normal.