Table of Contents
Advertisement
Always wait for the program to
■
finish. The device may still be
locked. Then turn on the device and
wait for it to unlock.
Q
Device Settings
You can override the following settings:
Device Settings
w
The volume of the final signal. The
■
volume of the key signal. Switch the
■
drum care information signal on/off.
■
You must enter setup mode to be able
to change these settings.
1/2/3/4...
stands on the
program selector
To activate setup mode:
1.
Set the program selector to position 1.
The appliance is switched on.
2.
touch the 0 Spin speed
button and hold it in while turning
the
program selector clockwise to
position 2. Release the 0 Centrifuge
speed release button.
The setting mode is activated and the
preset appears on the display panel.
Device Settings
Volume and
change drum care information
Use the ñ Ready in/Dry time button
to make the following settings at the
corresponding
to change program selector positions:
2: The volume of the final signal. 3: The
■
volume of the button signals.
■
0 = off, 1 = silent,
2 = medium, 3 = loud, 4 =
very loud
4: Switch the drum care information
■
signal on/off.
Ž
On
Πfrom
Exit setting mode
You can now end the process and open
the program selector in the from position.
The settings are saved.
huh
Sensors
Unbalanced load detection system
Sensors
The automatic unbalance loading system
detects an imbalance and ensures an even
distribution of the laundry by repeatedly
starting and stopping the drum spin.
If the laundry is extremely unevenly
distributed, the spin speed will be reduced
or the spin will not be stopped at all
performed for security reasons.
Note:
Distribute small and large items
of laundry evenly in the drum.
NL
43
Advertisement
Table of Contents
