Installation Procedure - Xerox WorkCentre 7228 System Administrator Manual

Installation Procedure

This section describes the configuration procedure to use the Scan to PC (FTP/SMB) feature on the
machine.
The following two steps are necessary to use the Scan to PC (FTP/SMB) feature.
•
Enabling the required ports and Setting TCP/IP
Enable the FTP port and SMB port on the Device, and then set the machine's IP address. If you will
be using SMB on a Microsoft Network, make sure to enable either DNS or WINS as part of the
TCP/IP configuration. For FTP, make sure that DNS is enabled.
•
Preparing an FTP directory or SMB shared folder on the receiving computer (server or workstation).
Create an FTP directory or SMB shared folder to receive scanned documents over the network.
166