Xerox WorkCentre 7228 System Administrator Manual page 175

3. Enable the SNMP port.
a. Select SNMP and then select Change Settings.
b. Select Port Status and then select Change Settings.
c. Select Enabled then select Save.
d. Select Close until the Port Settings screen is displayed.
e. Enable the Internet Service (HTTP) port using the same process as stated above.
f. Select Close repeatedly until the Network Settings screen is displayed.
4. Set an IP address.
If an IP address is already set, this step is not necessary. Also, in an environment with DHCP or
BOOTP, configure the way to obtain an IP address. If the address cannot be obtained automatically,
or manual configuration is preferred, configure an IP address, a subnet mask, and a gateway address
as follows.
a. Select Protocol Settings.
b. Select TCP/IP - Get IP Address and then select Change Settings.
c. Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual], and then select Save.
If you select anything other than [Manual], proceed to Step 5.
Note: When communicating by TCP/IP make sure to enable the use of a DNS (or WINS for SMB)
server. This is done using the machine's Internet Services web pages, displayed by typing the
machine's IP address into your web browser (as stated in the TCP/IP Dynamic Addressing Topic of
this guide).
d. On the Protocol Settings screen, select TCP/IP – IP Address and then Change Settings.
e. Enter the IP address using the numeric keypad.
Notes:
Enter the address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value in the range
from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
When you make an entry mistake, press the <C> (Clear) button and enter again.
When moving to the next value without entering all 3 digits, select [Next].
f. Select Save.
g. Configure TCP/IP – Subnet Mask and TCP/IP – Gateway Address using the same process as
stated above.
Notes:
Enter the Gateway address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value in
the range from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252, 254, and
255. However, you cannot use 0 between non-zero values.
If you do not set the gateway address, enter "0.0.0.0".
175