Set Up A Print Server, Queue, And Name On The Primary Server - Xerox WorkCentre 7228 System Administrator Manual

Set Up a Print Server, Queue, and Name on the Primary Server

1. Set up a Print Server, Queue, and Printer Configuration on the Primary Server using PCONSOLE.
Refer to the documentation supplied by Novell (www.novell.com) to complete this task.
Note: Record precisely (observe upper and lower case, punctuation etc.) the following: the Primary
Server name, Frame type used, Print Server name, Print Server password, and the Queue name
assigned. If your device services queues on multiple fileservers, the Print Server name must be the
same on all fileservers and the Print Server password must be the same on all fileservers.
Note regarding NetWare 4 (bindery): You can set up the printer on the NetWare 4 Server by performing
the following steps:
2. Create a Bindery Queue
3. Create a Bindery Print Server Name
4. Assign Print Server to Queue.
5. Access Quick setup and change Printer Location from Manual Load to Auto Load (Local)
6. Continue following setup instructions for Internet Services.
53