Electrical Safety; General Guidelines; Laser Safety; Power Cord - Xerox WorkCentre 6505N User Manual

Safety

Electrical Safety

This section includes:
•

General Guidelines

•

Laser Safety

on page 10
•

Power Cord

on page 10
General Guidelines
WARNING: Do not push objects, including paper clips or staples, into slots or openings on the
printer. Contact with a voltage point or shorting out a part could result in fire or electrical shock.
WARNING: Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are instructed to do so. Power must be OFF when performing
these installations. Disconnect the power cord when removing covers and guards for installing
optional equipment. Except for user-installable options, there are no parts that you can maintain
or service behind these covers.
Note: Leave the printer on for optimum performance. It does not pose a safety hazard. If,
however, you do not use the printer for an extended period, turn it off and unplug it.
The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the printer.
• The printer is exposed to water.
If any of these conditions occur, do the following:
1. Turn off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
Laser Safety
This printer complies with laser printer performance standards set by governmental, national, and
international agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardous
light because the beam is enclosed during all modes of customer operation and maintenance.
WARNING: Use of controls, adjustments, or performance of procedures other than the
procedures specified in this manual can result in hazardous radiation exposure.
Power Cord
• Use the power cord supplied with your printer.
10 WorkCentre 6505 Color Laser Multifunction Printer
User Guide
on page 10