Table of Contents
Advertisement
Mounting
5.1
Mounting the device
Taking the device out of the packaging
• The device must be removed from the packaging and carried by at least 2 persons.
• Wear appropriate protection to prevent injuries should the device be dropped.
1. Open the packaging carefully and remove from the monitor.
Make sure that the monitor cannot tip over.
2. Hold the device at the bottom and side, and remove from the packaging.
Mounting the device
The monitor has a VESA adapter/400x200 mm.
Since the screws are of particular importance for the installation, observe the following:
Fastening screw specifications
Number
Thread
Strength
Insertion depth
Tightening torque
● Make sure when installing the monitor that the adapter is designed for 4-fold safety
(monitor mass is approx. 40 kg).
● An installed stand must be sufficiently stable such that tilting (up to 10°) does not result in
toppling of the device.
● Mounting units, e.g. a stand or wall bracket, must be tested and approved by the
manufacturer for the weight to be supported. It is therefore advisable to use the monitor
manufacturer's mounting units since these satisfy the required demands.
RadiForce® LX470W
Instruction Manual, 06/2012, 1015263-003
CAUTION
4
M8
8.8 in accordance with ISO 898-1
10 mm (minimum) / 12 mm (maximum)
Max. 10 Nm
5
21
Advertisement
Table of Contents
