Canon imagePRESS C7000VP Reference Manual page 534

Printing has been canceled because the horizontal length of the perfect binding cover
is too long. Check the spine width and finishing size, then shorten the horizontal
perfect binding cover length.
Cause The width of the booklet is over 221 mm when you trim without the
Perfect Binding mode.
Booklet Width
Upper Limit: 221 mm
Fore Edge
Remedy 1 Change the paper for cover page with shorter length in order to set the
booklet width less than 221 mm. Measure the thickness of the main
document in advance, apply to the following formulas and judge.
(Length of the paper for the cover
2 221 mm
* Horizontal length to the feeding direction
Remedy 2 Basically, Remedy1 is priority. However, if you have is no cover paper of
other size, change the thickness of the main document to change the
trimming width less than 221 mm.
- Change the paper for the main document into thick ones.
- Add the number of the main document of book.
However, if the thickness of the main document exceeds 25 mm, since
another error occurs, cautions are required.
*
- Thickness of the main document)/
The perfect binding operation has been canceled because the volume of the content
pages exceeds the limit. Decrease the number of pages, or change to thinner paper,
and try again.
Cause The thickness of the width of the main document is over 25 mm.
Remedy Follow the solutions below to change the thickness of the main
document less than 25 mm.
- Change the paper for the main document into thin ones.
- Reduce the number of the page of main document.
Before performing perfect bookbinding, we recommend you to check the
curl state of a paper.
You need to print out the main document and a cover to the finisher or
stacker, and check that curl is within the specified value.
List of Error Messages A8-115