Seats And Fabric Parts - Jeep Gladiator 2024 Owner's Manual

Rear Carpet
1. Remove the grommets under the front seat (one left
and one right).
Carpet Split
2. Then pull the carpet out, to the rear and open the
carpet split around the front seat brackets.
3. Remove the rear Under Seat storage bin
(if equipped), by removing the four bolts that hold it
to the floor.
4. Remove the fastener bin from the rear floor, it is
held in by clips.
5. Remove the jack and tools by turning the wing bolt
counterclockwise, remove the wing bolt and then lift
the assembly out from under the seat.
6. Lift carpet off of the rear retainers (one left and one
right).
Rear Retainers
7. Remove carpet from the vehicle.
8. When reinstalling the carpet, perform these steps in
reverse order making sure that the carpet is tucked
under the scuffs, B-pillar, console, and then refasten
the grommets.

SEATS AND FABRIC PARTS

Use Mopar® Total Clean to clean fabric upholstery and
carpeting.
WARNING!
Do not use volatile solvents for cleaning purposes.
Many are potentially flammable, and if used in closed
areas they may cause respiratory harm.
SERVICING AND MAINTENANCE
Seat Belt Maintenance
CAUTION!
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the
fabric. Sun damage can also weaken the fabric
If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the
vehicle to wash them. Dry with a soft cloth.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
WARNING!
A frayed or torn seat belt could rip apart in a collision
and leave you with no protection. Inspect the seat
belt system periodically, checking for cuts, frays, or
loose parts. Damaged parts must be replaced imme-
diately. Do not disassemble or modify the seat belt
system. If your vehicle is involved in a collision, or if
you have questions regarding seat belt or retractor
conditions, take your vehicle to an authorized FCA
dealer or authorized FCA Certified Collision Care Pro-
gram facility for inspection.
291
8