Table of Contents
Advertisement
234
IN CASE OF EMERGENCY
See the following steps to remove:
1. Fold up the right rear seat.
2. Remove the jack and tools by turning the wing bolt
counterclockwise, remove the wing bolt and then
slide the assembly out from under the seat.
Removing the Wing Bolt
3. Release the tool bag straps from the jack and
remove tools from bag.
Jack And Tool Bag
4. Remove tool kit and assemble tools.
Jack And Tool Bag
There are two ways to assemble the tools:
Assembled For Spare Tire Lowering/Raising
1 — Lug Wrench
2 — Long Extension Without Spring Clip 2
3 — Long Extension With Spring Clip 3
4 — Long Extension With Spring Clip 4
NOTE:
If the tailgate is lowered, the jack extension with hook
can be added to this assembly to enable lowering of the
spare tire without having to raise the tailgate.
CAUTION!
•
The lug wrench can only be attached to extension 2.
•
When attaching the tool to the winch mechanism
be sure the large flared end opening on extension
4 is positioned correctly over the winch mecha-
nism adjusting nut.
•
Damage to the lug wrench, extensions and winch
mechanism may occur from improper tool
assembly
Assembled For Jack Operation
1 — Lug Wrench
2 — Long Extension 2
3 — Long Extension 3
4 — Long Extension 4
5 — Short Extension With Hook
Advertisement
Table of Contents
